procise纯PL流程点灯记录
一、概述
此篇记录使用procise工具构造JFMQL15T 纯PL工程，显示PL_LED闪烁；
硬件说明如下：
时钟引脚 Pl_CLK: U2 ,IO_L14P_T2_SRCC_34
PL_LED1 : E2, IO_L17P_T2_AD5P_35 PL_LED2: D6, IO_L2N_T0_AD8N_35
PL_LED3 : F5, IO_L5P_T0_AD9P_35 PL_LED4: E3, IO_L21N_T3_DQS_AD14N_35
二、新建procise工程
三、选择对应的Device
四、添加source Verilog文件
`timescale 1ns / 1ps
module pl_leda(
input sys_clk,
output reg [3:0] led
);
reg[31:0] timer_cnt;
always@(posedge sys_clk)
begin
if(timer_cnt >= 32’d49_999_999)
begin
led <= ~led;
timer_cnt <= 32’d0;
end
else
begin
led <= led;
timer_cnt <= timer_cnt + 32’d1;
end
end
endmodule
五、添加约束文件
编辑约束文件，添加管脚约束和时钟约束
NET “led[0]” IOSTANDARD = LVCMOS25;
NET “led[1]” IOSTANDARD = LVCMOS25;
NET “led[2]” IOSTANDARD = LVCMOS25;
NET “led[3]” IOSTANDARD = LVCMOS25;
NET “led[0]” LOC = E2;
NET “led[1]” LOC = D6;
NET “led[2]” LOC = F5;
NET “led[3]” LOC = E3;
NET “sys_clk” LOC = U2;
NET “Sys_clk” IOSTANDARD = LVCMOS18;
TIMESPEC TS_SYS_CLK = PERIOD “sys_clk” 50 MHz HIGH 50 %;
六、生成bitstream文件
七、下载调试
