学院 |
班级 |
学号 |
|||
姓名 |
日期 |
成绩 |
|||
实验题目 |
按键和中断 |
||||
实验目的 |
实现闪灯功能转换 |
||||
硬件原理 |
无 |
||||
关键代码及注释 |
/* Button Turns on and off a light emitting diode(LED) connected to digital pin 13, when pressing a pushbutton attached to pin 2. The circuit: * LED attached from pin 13 to ground * pushbutton attached to pin 2 from +3.3V * 10K resistor attached to pin 2 from ground * Note: on most Arduinos there is already an LED on the board attached to pin 13. created 2005 by DojoDave <http://www.0j0.org> modified 30 Aug 2011 by Tom Igoe modified Apr 27 2012 by Robert Wessels This example code is in the public domain. http://www.arduino.cc/en/Tutorial/Button */ // constants won't change. They're used here to // set pin numbers: const int buttonPin = PUSH2; // the number of the pushbutton pin const int ledPin1 = GREEN_LED; // the number of the LED pin const int ledPin2 = YELLOW_LED; const int ledPin3 = RED_LED; int ledState = LOW; int ledState1 = LOW; int ledState2 = LOW; int ledState3 = LOW; volatile bool state = HIGH; int count = 0; // variables will change: int buttonState = 0; // variable for reading the pushbutton status long previousMillis = 0; // will store last time LED was updated long term = 0; // the follow variables is a long because the time, measured in miliseconds, // will quickly become a bigger number than can be stored in an int. long interval = 1000; void setup() { // initialize the LED pin as an output: pinMode(ledPin1, OUTPUT); pinMode(ledPin2, OUTPUT); pinMode(ledPin3, OUTPUT); //digitalWrite(ledPin,state); pinMode(buttonPin,INPUT_PULLUP); attachInterrupt (buttonPin ,blink ,RISING); } void blink(){ state = !state; } void loop(){ unsigned long currentMillis = millis();
if(state==HIGH){ if(currentMillis - previousMillis > interval) { // save the last time you blinked the LED previousMillis = currentMillis; // if the LED is off turn it on and vice-versa: if (ledState == LOW) ledState = HIGH; else{ ledState = LOW;
} // set the LED with the ledState of the variable: digitalWrite(ledPin1, ledState); digitalWrite(ledPin2, ledState); digitalWrite(ledPin3, ledState); } } else{ if(currentMillis - previousMillis > interval) { previousMillis = currentMillis; if (ledState1 == LOW && ledState2 == LOW && ledState3 == LOW) ledState1 = HIGH; else if(ledState1 == HIGH){ ledState1 = LOW; ledState2 = HIGH; } else if(ledState2 == HIGH){ ledState2 = LOW; ledState3 = HIGH;
} else if(ledState3 == HIGH){ ledState3 = LOW; ledState1 = HIGH;
} digitalWrite(ledPin1, ledState1); digitalWrite(ledPin2, ledState2); digitalWrite(ledPin3, ledState3); } } } |
||||
实验步骤 |
在上次作业基础上加上了按钮,中断 |
||||
实验结果 |
![]() ![]() ![]() ![]() ![]() ![]() |
||||
思考与反馈 |
无 |
hdu物联网硬件实验3 按键和中断
2024-07-09 20:10:05 26 阅读