LVS_Director + KeepAlived
KeepAlived在该项目中的功能：
1. 管理IPVS的路由表（包括对RealServer做健康检查）
2. 实现调度器的HA
http://www.keepalived.org
Keepalived所执行的外部脚本命令建议使用绝对路径
=================================================================================
实施步骤：
1. 主/备调度器安装软件
[root@lvs-keepalived-master ~]# yum -y install ipvsadm keepalived
[root@lvs-keepalived-slave ~]# yum -y install ipvsadm keepalived
2. Keepalived
lvs-master
[root@ha-proxy-master ~]# vim /etc/keepalived/keepalived.conf
! Configuration File for keepalived
global_defs {
router_id lvs-keepalived-master #辅助改为lvs-backup
}
vrrp_instance VI_1 {
state MASTER
interface ens33 #VIP绑定接口
virtual_router_id 80 #VRID 同一组集群，主备一致
priority 100 #本节点优先级，辅助改为50
advert_int 1 #检查间隔，默认为1s
authentication {
auth_type PASS
auth_pass 1111
}
virtual_ipaddress {
192.168.246.110/32
}
}
virtual_server 192.168.246.110 80 {
#LVS配置
delay_loop 6 #健康检查rs时间间隔
lb_algo rr #LVS调度算法
lb_kind DR #LVS集群模式（路由模式）
protocol TCP #健康检查使用的协议
real_server 192.168.246.162 80 {
weight 1
inhibit_on_failure #当该节点失败时，把权重设置为0，而不是从IPVS中删除
TCP_CHECK {
#健康检查
connect_port 80 #检查的端口
connect_timeout 3 #连接超时的时间
}
}
real_server 192.168.246.163 80 {
weight 1
inhibit_on_failure
TCP_CHECK {
connect_timeout 3
connect_port 80
}
}
}
[root@lvs-keepalived-slave ~]# vim /etc/keepalived/keepalived.conf
! Configuration File for keepalived
global_defs {
router_id lvs-keepalived-slave
}
vrrp_instance VI_1 {
state BACKUP
interface ens33
virtual_router_id 80
priority 50
advert_int 1
authentication {
auth_type PASS
auth_pass 1111
}
virtual_ipaddress {
192.168.246.110/24
}
}
virtual_server 192.168.246.110 80 {
delay_loop 6
lb_algo rr
lb_kind DR
protocol TCP
real_server 192.168.246.162 80 {
weight 1
inhibit_on_failure
TCP_CHECK {
connect_port 80
connect_timeout 3
}
}
real_server 192.168.246.163 80 {
weight 1
inhibit_on_failure
TCP_CHECK {
connect_timeout 3
connect_port 80
}
}
}
3. 启动KeepAlived（主备均启动）
[root@lvs-keepalived-master ~]# systemctl start keepalived
[root@lvs-keepalived-master ~]# systemctl enable keepalived
[root@lvs-keepalived-master ~]# ipvsadm -Ln
IP Virtual Server version 1.2.1 (size=4096)
Prot LocalAddress:Port Scheduler Flags
-> RemoteAddress:Port Forward Weight ActiveConn InActConn
TCP 192.168.246.110:80 rr persistent 20
-> 192.168.246.162:80 Route 1 0 0
-> 192.168.246.163:80 Route 0 0 0
4. 所有RS配置(nginx1,nginx2)
配置好网站服务器，测试所有RS
[root@test-nginx1 ~]# yum install -y nginx
[root@test-nginx2 ~]# yum install -y nginx
[root@test-nginx1 ~]# ip addr add dev lo 192.168.246.110/32
[root@test-nginx1 ~]# echo "net.ipv4.conf.all.arp_ignore = 1" >> /etc/sysctl.conf
[root@test-nginx1 ~]# sysctl -p
[root@test-nginx1 ~]# echo "web1..." >> /usr/share/nginx/html/index.html
[root@test-nginx1 ~]# systemctl start nginx
注意事项：如果之前配置了vip，导致显示不了vip
需要执行systemctl stop keepalived #先停止在重启
` systemctl start keepalived `
即可显示vip
